HOW TO APPLY / REMOVE
How to apply StickyUps Sparkles and Wall Stickers
It couldn't be easier to apply our sparkles and wall stickers.
Start by choosing your surface - StickyUps can be applied to walls, wood, glass, concrete - basically any smooth, dry surface.
1. Clean
Wipe down the surface with a dry cloth so it's smooth, dry and free of dust, dirt and grease.
2. Plan
The wall stickers and Sparkles can be removed, but they cannot be re-used - so it's important to plan out where you will put them.
Cut roughly around the individual graphics and arrange them on your surface using scotch or masking tape, until you are happy with your design.
3. Prep
Lay your sheet of either the wall sticker or sparkles on a hard, flat surface – with the graphic side down.
Press firmly over the entire sheet with the edge of a credit card/plastic ruler. (This re-activates the bond between the StickyUp and the clear transfer tape.)
4. Peel
Keeping the graphic side down, and starting at one corner - slowly peel the white backing away from the clear tape. The graphic should stay attached to the clear front sheet, if it doesn't repeat step 3! You can then discard the white backing.
5. Apply
Once the white backing has been removed, carefully place one edge of the graphic onto the surface, in its desired position. Pressing firmly, move your hand slowly across the graphic. With the edge of a credit card finish the application by rubbing over the entire graphic.
6. Finish
Once smoothed down, carefully & slowly remove the clear top tape, peeling at a 45-degree angle. If some of the graphic begins to lift, stop pulling. Gently press it back onto your surface and then continue peeling.
7. Admire
Stand back and have a look! If you're proud of what you've done, we'd love to see the results - take a picture and send it to us.
How to remove StickyUps wall stickers and sparkles
StickyUps are easily removed without damage to surfaces.
Just soften then peel away!
Using a hairdryer on a low setting (warm – not hot!) gently blow over the sticker, this softens the adhesive. Then, starting at one corner, use your finger nail or a sharp pointed object to loosen the edge and gently peel the sticker away from the surface at a 180 degree angle.
Please Note:
In order to make your StickyUps experience a happy one, here’s some tips:
Please allow time for your painted walls to fully dry before using StickyUps (2-3 weeks). If applied before the paint is fully dry, the adhesive from the graphic could bond more strongly to the paint, potentially causing some paint to come off when decals are removed.
Usually StickyUps just peel off with no problems and no damage to surfaces. However, the condition of some painted surfaces and the location of your wall sticker can mean that some paint flecks are also removed. Depending on a combination of these factors, minor paint touch-ups could be required after removal. StickyUps is not liable for possible damage to surfaces.
